When PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC is used, the battery material to be treated is put into the crushing cylinder from the feed port, and then the first motor is started to make the conical wheel column rotate, at this time the battery material slides down the conical cylinder. Since the distance between the inner side wall of the funnel cylinder and the side wall of the cone wheel column gradually decreases from top to bottom, the battery material is fully crushed, and the scraper scrapes the battery material on the rotating cone wheel column.
Pulverized battery MATERIAL falls to PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC magnetic removal box inserted in the conductive clamp frame of the electromagnetic plate, because the conductive clamp frame makes the electromagnetic plate conductive, so the electromagnetic plate produces magnetism will fall material in the iron slag adsorption, And the rollers turn in the process, sweeping away the battery material stuck to the electromagnetic plate,
The treated battery material flows into the drawer box through the discharge port, and the outer side of the discharge port is covered with a dustproof box, which is used to prevent the battery powder slipping out of the discharge port from floating in the air, resulting in air pollution; The drawer box is inserted in the lower right side of the discharge port, and the PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC drawer box is easy to catch the treated battery material. Then through the pull frame, the electromagnetic plate is extracted to deal with the adsorbed iron slag.
Contact: DELLA
Mob: +86-13929907491
